How to Make a Soda Bottle Bird Feeder
How to Make a Soda Bottle Bird Feeder. Experienced home gardeners know that it's not just the plants that make a garden special; it's also the wildlife. Birds in particular add much to a garden, from the way they look to the fact that some eat undesirable insects. In the winter months, however, birds' food becomes scarce in some areas. Invite...
Experienced home gardeners know that it's not just the plants that make a garden special; it's also the wildlife. Birds in particular add much to a garden, from the way they look to the fact that some eat undesirable insects. In the winter months, however, birds' food becomes scarce in some areas. Invite non-migratory birds to linger through the cold winter in your garden by providing them with food in an up-cycled bird feeder made from a plastic soda bottle and other simple-to-find materials.
Things You'll Need
Tape measure or ruler
Sharp knife or scissors
Wooden chopstick, wooden dowel or wooden spoon
Masking tape
Funnel
Birdseed
String, wire or twine
Step 1
Remove and set aside a plastic soda bottle's cap. A soda bottle cap usually needs to be unscrewed for its removal. Rinse the soda bottle thoroughly with clean water.
Step 2
Soak the bottle in warm water until its label loosens, and remove the label. Let the bottle air-dry.
Step 3
Cut a quarter-size hole about 4 inches above the bottom of the soda bottle, using a sharp knife or scissors. Cut a second quarter-size hole opposite the first hole.
Step 4
Cut a small X -- about 1/4-inch wide -- roughly 1/2 inch below each quarter-size hole you made in the bottle.
Step 5
Slide a wooden chopstick, wooden dowel or wooden spoon -- handle first -- through the two X cuts. Both ends of the chopstick, dowel or spoon should protrude from the soda bottle, providing two perches for birds that come to feed.
Step 6
Cover the quarter-size holes with masking tape. Place a funnel in the soda bottle's top opening, and fill the bottle with birdseed.
Step 7
Remove the funnel from the soda bottle. Put the cap tightly back on the bottle.
Step 8
Tie string, wire or twine around the cap or the soda bottle's neck. Create a loop from which to hang the soda bottle.
Step 9
Hang the bottle, which is now a bird feeder, outdoors. Remove the masking tape from the bird feeder's quarter-size holes, allowing birds access to the birdseed.
Check out these related posts