Bulbs
Flower Basics
Flower Beds & Specialty Gardens
Flower Garden
Garden Furniture
Garden Gnomes
Garden Seeds
Garden Sheds
Garden Statues
Garden Tools & Supplies
Gardening Basics
Green & Organic
Groundcovers & Vines
Growing Annuals
Growing Basil
Growing Beans
Growing Berries
Growing Blueberries
Growing Cactus
Growing Corn
Growing Cotton
Growing Edibles
Growing Flowers
Growing Garlic
Growing Grapes
Growing Grass
Growing Herbs
Growing Jasmine
Growing Mint
Growing Mushrooms
Orchids
Growing Peanuts
Growing Perennials
Growing Plants
Growing Rosemary
Growing Roses
Growing Strawberries
Growing Sunflowers
Growing Thyme
Growing Tomatoes
Growing Tulips
Growing Vegetables
Herb Basics
Herb Garden
Indoor Growing
Landscaping Basics
Landscaping Patios
Landscaping Plants
Landscaping Shrubs
Landscaping Trees
Landscaping Walks & Pathways
Lawn Basics
Lawn Maintenance
Lawn Mowers
Lawn Ornaments
Lawn Planting
Lawn Tools
Outdoor Growing
Overall Landscape Planning
Pests, Weeds & Problems
Plant Basics
Rock Garden
Rose Garden
Shrubs
Soil
Specialty Gardens
Trees
Vegetable Garden
Yard Maintenance
How to Reinforce Rafters for a Swing
How to Reinforce Rafters for a Swing. Hanging swings are often added to an outdoor porch or a favorite corner of a quiet room to create a comfortable retreat. If the swing is to be structurally stable, you must bolt the support fasteners into the ceiling rafters, and not just screw them into drywall or a wood ceiling. In come cases, if the roof...
Hanging swings are often added to an outdoor porch or a favorite corner of a quiet room to create a comfortable retreat. If the swing is to be structurally stable, you must bolt the support fasteners into the ceiling rafters, and not just screw them into drywall or a wood ceiling. In come cases, if the roof rafter is old, you should reinforce it before adding the weight of a hanging swing.
Things You'll Need
Short length of 2-by-6 lumber -- approximately 4 feet
Drill with assorted drill bits and Phillips head driver bits
Wire hanger, unwound and straightened
2 1/2-inch coarse thread screws
(2) C-clamps or bar clamps
Access to the roof or ceiling area above the installation site
Flashlight
Tape measure
Ladder to access the attic or crawlspace, if necessary
Drill a small hole in the ceiling where the hanging swing will be installed. Poke the wire hanger into the hole so that it extends into the attic cavity. This wire will guide you to the proper spot in the attic in the next step.
Enter the attic or crawl space, bringing the flashlight, drill, 2-by-6, C-clamps, measuring tape and 2 1/2-inch screws with you. Locate the wire inserted through the ceiling, and then locate the ceiling rafter that is closest to the spot.
Clear the insulation away from the ceiling rafter, and place the short piece of 2-by-6 alongside the rafter.
Clamp the two pieces of wood together using the C-clamps, and then screw the two pieces of wood together using the 2 1/2-inch screws. The piece of 2-by-6 you add to the rafter should lie flush with the ceiling and flush against the old rafter for maximum strength. Use a number of screws so that the strength of the additional 2-by-6 is added to the existing rafter.
Before you leave the attic, measure the location of the reinforced rafter in relation to the guide wire you inserted into the attic. Use this measurement to locate the new rafter once you return to the room where the swing is installed. Make sure the lag screws for the swing are anchored firmly into the reinforced rafter as you install ceiling anchors for the swing.
