Bulbs
Flower Basics
Flower Beds & Specialty Gardens
Flower Garden
Garden Furniture
Garden Gnomes
Garden Seeds
Garden Sheds
Garden Statues
Garden Tools & Supplies
Gardening Basics
Green & Organic
Groundcovers & Vines
Growing Annuals
Growing Basil
Growing Beans
Growing Berries
Growing Blueberries
Growing Cactus
Growing Corn
Growing Cotton
Growing Edibles
Growing Flowers
Growing Garlic
Growing Grapes
Growing Grass
Growing Herbs
Growing Jasmine
Growing Mint
Growing Mushrooms
Orchids
Growing Peanuts
Growing Perennials
Growing Plants
Growing Rosemary
Growing Roses
Growing Strawberries
Growing Sunflowers
Growing Thyme
Growing Tomatoes
Growing Tulips
Growing Vegetables
Herb Basics
Herb Garden
Indoor Growing
Landscaping Basics
Landscaping Patios
Landscaping Plants
Landscaping Shrubs
Landscaping Trees
Landscaping Walks & Pathways
Lawn Basics
Lawn Maintenance
Lawn Mowers
Lawn Ornaments
Lawn Planting
Lawn Tools
Outdoor Growing
Overall Landscape Planning
Pests, Weeds & Problems
Plant Basics
Rock Garden
Rose Garden
Shrubs
Soil
Specialty Gardens
Trees
Vegetable Garden
Yard Maintenance
How to Adjust the Carburetor for a Poulan Woodshark
How to Adjust the Carburetor for a Poulan Woodshark. The Poulan Woodshark is a lightweight chain saw powered by a 2-cycle gasoline engine. The carburetor mixes fuel with the proper amount of air, and sprays the mixture into the combustion chamber where the spark from the spark plug ignites it to drive the engine piston and, ultimately, the chain....
The Poulan Woodshark is a lightweight chain saw powered by a 2-cycle gasoline engine. The carburetor mixes fuel with the proper amount of air, and sprays the mixture into the combustion chamber where the spark from the spark plug ignites it to drive the engine piston and, ultimately, the chain. The carburetor is preset at the factory, but you may have to adjust the idle speed after you use the saw. Other carburetor adjustments are possible, but the manufacturer recommends they be performed by a licensed service representative to avoid engine damage.
Things You'll Need
Phillips screwdriver
Flat-head screwdriver
Place the saw on a flat bench and ensure there are no obstructions around the chain, which will spin during this procedure.
Unscrew and remove the three screws holding the engine cover and remove the cover. Then remove the air filter cover and air filter. The carburetor adjustment screw is located behind the air filter. Clean the filter with soap and water before putting it back, or replace it with a new one. Replace the air filter and engine covers.
Locate the idle adjustment screw. It is marked "T" and is just above the priming bulb.
Start the saw and let it idle for two or three minutes to warm up. If it's idling too slow, you may have to keep the throttle engaged. Be sure to keep clear of the chain, which will be spinning.
Turn the screw with a flat-head screwdriver. If the saw is idling too slow, turn the screw clockwise to increase engine speed. If the chain begins turning, turn the screw counterclockwise until it stops. Try to find the sweet spot -- where the engine runs smoothly without engaging the chain.
Tips & Warnings
The carburetor has two other adjustment screws, but they are fitted with guards to prevent adjustment. If your saw runs rough, bring it to a service professional to have these screws adjusted.
Perform this adjustment when no one else is present who could inadvertently come in contact with the chain.
