Bulbs
Flower Basics
Flower Beds & Specialty Gardens
Flower Garden
Garden Furniture
Garden Gnomes
Garden Seeds
Garden Sheds
Garden Statues
Garden Tools & Supplies
Gardening Basics
Green & Organic
Groundcovers & Vines
Growing Annuals
Growing Basil
Growing Beans
Growing Berries
Growing Blueberries
Growing Cactus
Growing Corn
Growing Cotton
Growing Edibles
Growing Flowers
Growing Garlic
Growing Grapes
Growing Grass
Growing Herbs
Growing Jasmine
Growing Mint
Growing Mushrooms
Orchids
Growing Peanuts
Growing Perennials
Growing Plants
Growing Rosemary
Growing Roses
Growing Strawberries
Growing Sunflowers
Growing Thyme
Growing Tomatoes
Growing Tulips
Growing Vegetables
Herb Basics
Herb Garden
Indoor Growing
Landscaping Basics
Landscaping Patios
Landscaping Plants
Landscaping Shrubs
Landscaping Trees
Landscaping Walks & Pathways
Lawn Basics
Lawn Maintenance
Lawn Mowers
Lawn Ornaments
Lawn Planting
Lawn Tools
Outdoor Growing
Overall Landscape Planning
Pests, Weeds & Problems
Plant Basics
Rock Garden
Rose Garden
Shrubs
Soil
Specialty Gardens
Trees
Vegetable Garden
Yard Maintenance
How to Correct the Spark Plug Gap Setting in a Husqvarna 55 Rancher
How to Correct the Spark Plug Gap Setting in a Husqvarna 55 Rancher. The Husqvarna 55 Rancher chainsaws use a single spark plug. The spark plug gap setting refers to the distance between the electrodes of the spark plug on the end of the plug projecting into the combustion chamber. An improper spark plug gap can cause hard starting, rough running...
The Husqvarna 55 Rancher chainsaws use a single spark plug. The spark plug gap setting refers to the distance between the electrodes of the spark plug on the end of the plug projecting into the combustion chamber. An improper spark plug gap can cause hard starting, rough running and inefficient burning of the fuel-air charge. Replace the spark plug after a month of operation; but clean and regap the plug as needed to correct performance problems. Adjust the spark plug gap using basic tools.
Things You'll Need
Phillips screwdriver
Chainsaw multi-tool or a ratchet and spark plug socket
Spark plug gap tool
Remove the four screws from the top of the engine cover using a Phillips screwdriver. Lift the engine cover off.
Grasp the boot of the spark plug wire and pull the spark plug wire off the spark plug. Remove the spark plug, using the chainsaw multi-tool or a ratchet and plug socket.
Gently tap the spark plug electrode on a clean, hard surface to slightly collapse the gap. Insert the gap tool into the gap between the electrodes and rotate the tool until the gap reads 0.02 inches.
Install the spark plug and tighten it securely, using the chainsaw multi-tool or a ratchet and plug socket. Snap the spark plug wire on the spark plug.
Install the engine cover and tighten the screws, using a Phillips screwdriver.
Tips & Warnings
Damaged or carbon fouled plugs must be replaced. Always use NGK BPMR 7A or Champion RCJ 7Y spark plugs set to a 0.02-inch gap.
Handle the spark plug with care. Dropping the plug can damage the ceramic insulator or collapse the gap. Inspect any dropped plugs for damage and recheck the gap before installing.
