How to Repair an Asphalt Driveway
How to Repair an Asphalt Driveway. Sealing a driveway doesn't significantly prolong its life, but promptly filling cracks and holes and cleaning up oil spills do. Although you would typically handle fixes in the summer when you apply sealer, winter is the best time to fill cracks--and when it comes to most driveway repairs, there's no time like the...
Sealing a driveway doesn't significantly prolong its life, but promptly filling cracks and holes and cleaning up oil spills do. Although you would typically handle fixes in the summer when you apply sealer, winter is the best time to fill cracks--and when it comes to most driveway repairs, there's no time like the present.
Things You'll Need
Cold-patch Blacktop
Driveway Cleaner
Oil-spot Primer
Air Compressor Or Garden Hose With Nozzle
Broom
Brush Or Squeegee Applicator
Iron Rake
Shovel Or Trowel
Stiff Broom
Putty Knife
Acrylic Driveway Sealer Or Filler
Caulking Gun
Scrap Plywood
Shop Vacuum
Tamper Or 4-by-4
Rubberized asphalt-emulsion crack filler
Ice chipper, lawn-edging tool or spade
Cleaning the driveway
Use an ice chipper, a lawn-edging tool or a spade to scrape grass or weeds off the driveway and out of cracks.
Remove any loose asphalt from damaged or cracked areas with a blast of water from a garden hose or with compressed air.
Brush off all debris with a broom.
Scrub the driveway with diluted driveway cleaner to remove all dirt and oil film. Repeat as necessary to remove oil stains, and apply an oil-spot primer on any remaining stains.
Hose the driveway with as much pressure as possible. Start on the uphill and rinse toward the sides.
Use a shop vacuum to remove all loose debris from cracks. These must be very clean and dry before filling.
Let the driveway dry thoroughly before moving to the next step.
Making repairs
For cracks 1/8 to 1/2 inch (3 to 12 mm) wide, use rubberized asphalt-emulsion crack filler, applied with a caulking gun or poured. Avoid getting the filler on the surface. Smooth it with a putty knife.
For a very wide crack or pothole, shovel in packaged cold-patch blacktop, leveling large areas with an iron rake. Compact the material with a rented tamper or the end of a 4-by-4. Add more material until the hole is slightly overfilled. Cover it with scrap plywood and drive over it.
Filling and sealing
Mist the driveway with water. Then pour a ribbon of acrylic driveway sealer or filler 1 foot (30 cm) wide across the driveway. Spread the strip to a width of 3 to 4 feet (about 1 m) with a brush or squeegee applicator.
Remove all excess sealer, using the brush or squeegee and pulling toward you. Work your way down the driveway.
Tips & Warnings
Undercut the edges of a pothole with a cold chisel and mason's hammer.
For cracks more than 1/2 inch (12 mm) wide, stuff in a nonporous foam backer rod until the crack is only as deep as it is wide.
Wear eye protection such as goggles when cleaning, chiseling or hosing the driveway.
Check out these related posts