How to Install a Patio Umbrella Without a Stand
How to Install a Patio Umbrella Without a Stand. The heavy, clunky umbrella stand is typically an optional and somewhat pricey purchase when you buy your patio set. It resides under the table and holds the umbrella upright and secures it from flying away during windy weather. For those that don’t want to restrict the use of the umbrella to...
The heavy, clunky umbrella stand is typically an optional and somewhat pricey purchase when you buy your patio set. It resides under the table and holds the umbrella upright and secures it from flying away during windy weather. For those that don’t want to restrict the use of the umbrella to the patio furniture, there are other, more decorative methods that may replace the umbrella stand. A stunning planter that coordinates with your other outdoor furnishings makes an interesting and decorative umbrella stand.
Things You'll Need
15-inch tall, 20-inch wide planting pot or other container
Measuring tape
1?-inch ABS pipe, three feet in length
Saw
Wire or nylon screen
1 cubic foot of lava rock gravel or crushed lava rock
Container to mix concrete
50 lb. bag of concrete
Trowel
Carpenter’s level
? inch dowel, 3 ft. in length
Dowels
Potting soil
Plants
Choose a planter with a broad base so that it isn’t easily knocked or blown over.
Cut the ABS 8 inches taller than the pot’s depth.
Lay a square of screening material on the bottom of the pot, over the drainage holes.
Add one inch of lava rock to the pot and stick the ABS into it, in the center. Add the remaining lava rock to the pot, spreading it evenly.
Mix the concrete according to package instructions and add three inches of it over the lava rocks in the container. Use a trowel or other flat instrument to slope the concrete slightly away from the ABS. Use a carpenter’s level to check that the container is level and the ABS is perfectly vertical.
Use the saw to cut the dowel into six-inch pieces. Stick them through the concrete, while it is still wet, equally spaced around the pot to create drainage holes. Move the dowels in a circular motion after you’ve placed them in the concrete. This allows for easier removal when the concrete dries. Remove the dowels the next day, after the concrete sets.
Fill the pot to within two inches of the top with potting soil. Plant ornamentals around the ABS and water until the excess drains from the bottom of the pot.
Check out these related posts